Bloodhound SSC Vehicle Technical Specification: configuration 11, June 2012
X, Y, Z co-ordinates for the position of Major Components/Assemblies*:
|Rear Wheels/suspension||mm||15900,0,635||WHEEL CENTRE ,X,Y,Z|
|Rocket engine & casing||mm||16436.95,0,737.3808||REAR FACE OF ROCKET NOZZLE X,Y,Z ROCKET 2 DEGREES NOSE DOWN|
|Eurojet EJ200||mm||12406.75,0,1570||FRONT FACE OF JET X,Y,Z|
|CHASSIS COCKPIT SPLIT||mm||X=10185|
|TOP AND BOTTOM CHASSIS SPLIT||mm||Z=1042|
|Rear structure and skins||mm|
|EJ200 intake structure||mm|
|Front wheels||mm||7000,0,635||CENTRE OF WHEEL X,Y,Z|
|APU Cooling system||mm|
*All X,Y,Z coordinates refer to vehicle datum as per BLOODHOUND Design Office Standards:
x=0 at 7000mm ahead of front axle centreline
y=0 at mid-point of wheel track
z=0 at 200mm below ground level
BLOODHOUND Programme Limited has provided this data as advisory and indicative and specifically and exclusively for the purpose of education. All facts, figures, concepts and principals provided relate only to the BLOODHOUND project. They may be inaccurate, out of date and subject to revision without notice. Under no circumstances should the data provided (or any derivative thereof) be used in whole or in part for any project, except in a purely theoretical environment. It should be understood that the entire project is experimental with high levels of personal risk and danger.
BLOODHOUND Programme Limited, its directors, designers and associates do not accept any responsibility or liability whatsoever for use by any party of the data provided in breach of these terms.
All data provided by BLOODHOUND Programme Limited is confidential and proprietary to the BLOODHOUND Programme Limited. All such data shall only be used for the purposes of education and shall not be used by any party for commercial gain.